Visible Compliance: What a Regulator Really Sees First

Inspector reviewing bunding area with damaged containment edge, spill staining, and nearby drain in warehouse

An inspector walks into your warehouse. Before they read a procedure…Before they check capacity calculations…Before they ask for documentation… They look at the floor. They look at the bund line.They look at the storage area.They look at the drain nearby. What they see in the first 30 seconds tells them whether containment is being managed …

Read more

Prevent Forklift Damage to Floor Bunding (Before It Fails)

Forklift turning across floor bunding causing edge lifting and seal failure in a warehouse traffic area

You installed floor bunding last quarter. It looked compliant.It looked sealed.Job done. Then a loaded forklift turns too tightly at the bund edge. The edge lifts.The adhesive tears.The seal opens up. Your containment perimeter now has a gap. What looked like a finished installation is now a containment risk. Under the WHS Regulation 2011 (Qld), …

Read more

Portable Bunding for Civil & Temporary Sites

Temporary Site Bunding Solutions

Here’s the thing. You’re managing a temporary earthworks site. Heavy machinery exits the site daily, meaning mud, hydrocarbons and sediment track toward public roads. Under Queensland environmental and biosecurity requirements, vehicle washdown is mandatory before leaving certain sites. Failure to comply with these requirements can result in: You need washdown containment, but it needs to …

Read more

Segregating Dangerous Goods in Bunded Areas

Segregating Dangerous Goods In Bunded Areas

What Gets Sites in Trouble Key Point: If incompatible liquids leak into the same sump, the bund may have contained the spill, but it will have failed to control the consequences. You walk past your chemical storage area. On one bunded pallet you have: They’ve been sitting there for months. Nothing has leaked. It looks …

Read more

Rainwater & Bund Capacity: The Hidden Compliance Failure

Rainwater filling an outdoor spill containment bund showing reduced containment capacity and solutions like bund covers and dewatering systems

A Storm Passes Through. Your Bund Is Full. You inspect your outdoor bund after heavy rain. It’s full of water. If a container ruptured right now, there would be no capacity left to contain the spill. Under AS 1940:2017, the required bund capacity must be available at all times. Why Rainwater Creates a Compliance Risk …

Read more

Bunding Without Drilling: How to Stay Compliant Without Touching the Slab

Bunding without Drilling - Featured mage

No Drilling Into the Slab You email the property manager: “We need to install floor bunding for chemical compliance.” The reply comes back quickly: “No drilling into the slab. No exceptions.” Now, what? Under WHS Regulation 2011 (Qld) s357, hazardous chemicals must be provided with secondary containment. But your lease prohibits drilling into the concrete. …

Read more

Why Floor Bunding Fails at the Joints – And How to Eliminate the Risk 

Why Floor Bunding Fails at the Joints - and how to Eliminate the Risk

When floor bunding systems experience performance issues, it is most commonly at the joints. Whether installed in workshops, wash bays, warehouses, fuel storage areas, or industrial facilities, in sectional bunding systems, the joint is typically the most mechanically sensitive point. And the number of joints in your installation directly affects your long-term risk.  The Hidden …

Read more

Port Augusta City Council – Heavy Duty Containment Boom Case Study

Heavy duty XR5 containment boom separating oil and grease in waste transfer pond at Port Augusta facility.

Project: Heavy Duty Containment Boom (XR5 Fabric)Client: Port Augusta City CouncilApplication: Waste Transfer Facility – Oil & Grease Separation The Challenge Port Augusta City Council required a containment solution to separate heavy oils and grease from a waste transfer pond. The pond receives discharge from trucks, resulting in: The objective was to isolate the top …

Read more

City Wide Detailing – Relocatable Vehicle Wash Mat Case Study

Custom 10m x 5m relocatable vehicle wash mat deployed at City Wide Detailing facility.

Client: City Wide DetailingSystem Supplied: Custom 10m x 5m Relocatable Wash Mat Operational Requirement City Wide Detailing required a compliant washdown solution that could be relocated when they moved premises. A permanently installed wash bay was not suitable due to the temporary nature of their site lease. They needed a contained wash area that would: …

Read more

Stormwater Management for Industrial Sites (Australia)

Stormwater management in industrial settings

Stormwater management, in an industrial setting, means ensuring that rainwater leaving your site is not contaminated by site activities. Any water that has come into contact with oils, chemicals, sediment, washdown residues, or process waste must be contained, treated, or diverted to a lawful discharge pathway. Key Takeaways Stormwater management is a practical compliance issue …

Read more

Client feedback

Trusted by Organisations Across Australia

Feedback from councils, contractors and organisations working with Trade Enviro across Australia.

★★★★★

“A pleasure to deal with from quote stage right through to delivery. You’re fully informed throughout the process.”

Garry SollyMcMahon Services

★★★★★

“Fantastic service and very quick turnaround. This is the second lot of bunds we’ve purchased and we cannot fault the service or product.”

Ben EnglishAtlas CEA

★★★★★

“We are very happy with the service and product provided. Delivery was on time and the backup service couldn’t be faulted. I would most certainly use Trade Enviro again.”

Luke HilleryHillery Group